When I have a plan with adjacent areas combined, and I choose the spiral pattern, I would like the option to have the total area spiraled instead of doing each area as its own spiral, then going on to the next area.
Do you mean you have a plan with multiple areas in it? It will work just like the Yarbo app in that case. You would need to have a single large area for it to spiral all of it.
In Yardstick you could make a new area the covers all your smaller areas, or you could combine your existing areas in singe large area. If you do the latter, you would lose the ability to cut the smaller areas separately.
Yes, I have 14 different areas that I need to be able to mow independently at times, but could be combined into fewer areas depending on the weather and grass dryness. Combining areas goes faster, because there are fewer turns (same goes for other patterns also). It also breakes up areas into different patterns which is good for the grass. I was thinking that Yardstick would have the ability to make a temp plan that combines selected areas and applies the settings (as long as the settings are common). The number of different combinations I could have of combined areas can be large.
Yardstick has to work within Yarbo’s framework. This one steps outside what’s possible I’m afraid. Maybe others have some suggestions I haven’t thought of.
Perhaps the opposite approach. Have one large area, and what are now the individual areas become no-go zones instead. Mowing sections are made by disabled no-go zones. Pathways to get from the dock to any area would be tricker to figure out without crossing no-go zones.
That might just work. It’s still a lot of NGZs to manage. The Scheduler allows disabling them on a schedule but it could be tricky to coordinate everything.
Only thing is the NGZ’s cannot isolate or narrow too small for the core any portion of the area or else it will fail to start the plan.
